ENGINEER.48
-
-
Electromagnetic brake for holding, but cause of great wear dust.
2021/7/31 electromagnetic brake
Today's note is about the cause of the great wear powder even though it is an electromagnetic brake for holding. In the past, I have designed electromagnetic brakes for servo motors and general motors. At that time, ...
-
-
What to do if Toolbox database "swbrowser.sldedb" cannot be found in SolidWorks
2023/11/29 Solidworks
Today's note is about "What to do if you can't find the Toolbox database "swbrowser.sldedb" in SolidWorks". I recently installed SolidWorks 2018 in ...
-
-
Relationship between mechanical stopper and overrun sensor
2021/11/15 Sensor, Design method
Today's note is about "the positional relationship between the mechanical stopper and the overrun sensor". The other day, in a "motor + ball screw" mechanism of a piece of machinery, a mechanical stopper and an overrun sensor ...
-
-
How to create a going/returning cable bear model in SolidWorks
2024/11/24 2DCAD／3DCAD
Today's note is about "how to make a go/no-go cable bear model in SolidWorks". I do design work in SolidWorks, and the most tedious part of making a model is the cae ...
-
-
Calculation of impact value, impact force, and load on conveyor stopper
2025/10/19 Conveyor, Shock absorbers, Design method
Today's memo is about "Calculating Impact Value, Impact Force, and Load on Conveyor Stoppers". When a conveyor is used to transport a workpiece horizontally or to stop a vertically falling workpiece with a stopper, it is important to know the load applied to the ...
-
-
How to order some of the components of MISUMI assemblies (e.g., conveyors) individually
2024/6/17 Misumi
Today's note is about "how to order some of the component parts of MISUMI assemblies (e.g. conveyors) individually. When you purchase a MISUMI assembly, parts that wear out or need to be replaced periodically ...
-
-
Insert/Helisert pre-bore depth calculation method
2024/2/23 insert
Today's note is on "How to Calculate Insert/Helisert Downhole Depth". Machines often use bolts for fastening, and sometimes the structure is made of aluminum or other lightweight materials, so the ...
-
-
These are the five collision check points in mechanical design
2025/11/13 The story of machine design
Today I note "Where to Check for Interference in Mechanical Design". In this post, I'm noting 5 ways to do interference checking that don't rely on tools. Suddenly, the other day I set up a ...
-
-
Corrosion Control for SUS Products. A Note on Passivation Treatment (Passivate Treatment)
2025/10/19 Stainless steel, Surface treatment
Today I will make a "Corrosion Control Measures for SUS Products. A note on passivation treatment". Corrosion of SUS products is a problem that can be caused by oil and surface ...
-
-
The theory of the positioning method, "The Rule of 3, 2, 1."
2025/10/13 Method of positioning
Here we note one of the theories to be held in the Complete Guide to Positioning, the "Rule of 3, 2, 1," which is the basis of how to position a plate (square) member. This is the ...
